Jeep Liberty: Rear Tail/Stop, Turn Signal, And Back-Up Lamp
1. Open the liftgate.
2. Remove the screws that fasten the taillamp housing to the vehicle.
3. Pull the taillamp housing straight back to separate it from the vehicle.
4. Disconnect the electrical connector.
5. Remove the two screws that fasten the back plate to the taillamp housing.
6. Separate the back plate from the taillamp housing.
7. Pull the appropriate bulb(s) out of the back plate and insert the replacement bulb(s).
8. Install the back plate and screws into the taillamp housing.
9. Connect the electrical connector.
10. Install the taillamp housing and screws.
11. Close the liftgate.
Front Fog Lamp
1. Open the hood. 2. Reach behind the headlamp housing to access the bulb. 3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing. 4. ...Fluid Capacities
...See also:
Storing Radio Station Presets
There are a few ways to store presets.
Up to 36 preset stations can be stored. AM, FM, and XM, if equipped, can be mixed.
1. From the AM, FM, or XM main page, press and hold one of the preset screen ...
Opening Sunroof — Express
Press the switch rearward and release it within one-half
second and the sunroof will open automatically from any
position. The sunroof will open fully and stop automatically.
This is called “Ex ...
Towing load/specification
1: All towing above 1,000 lb (454 kg) requires the use of trailer brakes.
2: Sway control devices are not offered by NISSAN. See a professional
trailer/hitch outlet for a properly
designed sway ...