Subaru Forester: Rear seatbelts (except rear center seatbelt) - Fastening the seatbelt - Seatbelts - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: Rear seatbelts (except rear center seatbelt)

1. Sit well back in the seat.

2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving a strong pull on it, then pull it out slowly again.

3. Insert the tongue plate into the buckle

3. Insert the tongue plate into the buckle until you hear a click.

4. To make the lap part tight, pull up on

4. To make the lap part tight, pull up on the shoulder belt.

5. Place the lap belt as low as possible on your hips, not on your waist.

    Unfastening the seatbelt
    Unfastening the seatbelt Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...

    Unfastening the seatbelt
    Unfastening the seatbelt Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...

    See also:

    Turning the System On and Off
    The URPA system can be turned on and off using the infotainment system controls. See Vehicle Personalization on page 5‑33 for more information. When the system is off, PARK ASSIST OFF display ...

    Instrument panel light control
    The brightness of the instrument panel lights can be adjusted. 1 Brighter 2 Darker When the headlight switch is turned on, the brightness will be reduced slightly unless the control dial is tu ...

    Cleaning the wiper blades
    WARNING Before cleaning the windshield or wiper blades, switch off the windshield wipers and remove the SmartKey from the ignition lock. On vehicles with KEYLESS-GO, press the Start/Stop but ...