Jeep Liberty: Infants And Child Restraints
Safety experts recommend that children ride rearwardfacing in the vehicle until they are two years old or until they reach either the height or weight limit of their rear facing child safety seat. Two types of child restraints can be used rearward-facing: infant carriers and convertible child seats.
The infant carrier is only used rearward-facing in the vehicle. It is recommended for children from birth until they reach the weight or height limit of the infant carrier.
Convertible child seats can be used either rearwardfacing or forward-facing in the vehicle. Convertible child seats often have a higher weight limit in the rearwardfacing direction than infant carriers do, so they can be used rearward-facing by children who have outgrown their infant carrier but are still less than at least two years old. Children should remain rearward-facing until they reach the highest weight or height allowed by their convertible child seat. Both types of child restraints are held in the vehicle by the lap/shoulder belt or the LATCH child restraint anchor system. Refer to “Lower Anchors and Tether for CHildren (LATCH)”.
WARNING!
Rearward-facing child seats must never be used in
the front seat of a vehicle with the front passenger air
bag unless the air bag is turned off. An air bag
deployment could cause severe injury or death to
infants in this position.
Child Restraints
Everyone in your vehicle needs to be buckled up all the time, including babies and children. Every state in the United States and all Canadian provinces require that small children ride in prope ...Older Children And Child Restraints
Children who are two years old or who have outgrown their rear-facing convertible child seat can ride forwardfacing in the vehicle. Forward-facing child seats and convertible child seats used in ...See also:
Trailer hitch - australia only
When selecting a drawbar for the receiver, the
following dimensions must be adhered to:
A. The maximum recommended drawbar
length is 178mm (7 in).
B. To achieve the maximum ball height, a
drawb ...
How can I prepare for my next OBD II emission inspection?
• If your Check Engine (MIL) light is lit – or
was lit but went out without service, have
your vehicle diagnosed and, if necessary,
serviced by a qualified Volvo technician.
• If you rece ...
Initializing the registered data
To initialize the registered data, perform
the following procedure.
1. Select the “INITIALIZE” menu.
2. Select the “CONFIRM” menu. First
“PLEASE WAIT”, then “INITIALIZED” is
di ...