Kia Sportage: Lubricants and fluids - Maintenance - Kia Sportage Owner's ManualKia Sportage: Lubricants and fluids

Checking the washer fluid level The reservoir is translucent so that you can

Checking the washer fluid level The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characteristics in cold climates to prevent freezing.

WARNING - Coolant • Do not use radiator coolant or antifreeze in the washer fluid reservoir. • Radiator coolant can severely obscure visibility when sprayed on the windshield and may cause loss of vehicle control or damage to paint and body trim. • Windshield Washer fluid agents contain some amounts of alcohol and can be flammable under certain circumstances. Do not allow sparks or flame to contact the washer fluid or the washer fluid reservoir. Damage to the vehicle or it's occupants could occur. • Windshield washer fluid is poisonous to humans and animals. Do not drink and avoid contacting windshield washer fluid. Serious injury or death could occur.

Body lubrication All moving points of the body, such as door hinges, hood hinges, and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather. Make sure the engine hood secondary latch keeps the hood from opening when the primary latch is released.

    Transfer case (4WD)
    Checking or changing transfer case fluid Have transfer case fluid checked or changed by an Authorized Kia Dealer according to the Maintenance Schedule at the beginning of this section. Use only th ...

    Air cleaner
    Element replacement Have the air cleaner element checked and replaced in accordance with the maintenance schedule. NOTICE Do not drive with the air cleaner removed; this will result in excessive ...

    See also:

    Disposing of old batteries
    Worn out batteries should be disposed of in an environmentally responsible manner. ...

    Cleaning the trailer tow hitch
    The ball coupling must be cleaned if it becomes dirty or corroded. Remove rust on the ball of the ball coupling, e.g. with a wire brush. Remove dirt with a clean, lint-free cloth or a brush. A ...

    Backing up behind a projecting object
    Backing up behind a projecting object The position C is shown further than the position B in the display. However, the position C is actually at the same distance as the position A . The vehi ...