Range Rover Evoque: Locking and arming the alarm
CAUTION: No modifications or
additions should be made to the
anti-theft system. Such changes could
cause the system to malfunction.
There are two levels of security: - Single locking. With all doors and tailgate closed, press the lock button on the Smart Key once, to Single lock the vehicle and activate the perimeter alarm. The alarm LED in the instrument panel will start to flash and the hazard warning lamps will flash once to confirm locking. Power fold mirrors will fold in (if enabled).
- Double locking. A second press within three seconds will Double lock the vehicle and activate the full alarm system. The hazard warning lamps will flash a second time to confirm the enhanced Double lock state. An audible confirmation may also be given. The audible warning can be set/disabled via Audible Lock Warning in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU.
The vehicle will not lock if
a door, the
tailgate or the bonnet aperture is open,
or the ignition is ON. No lamps will flash
and if the lock request is via the Smart
Key, there will be an audible mislock
warning.
Ensure that the Smart Key
does not
remain in the vehicle prior to closure. If
the vehicle is in an area of localised RF
interference or the Smart Key is
shielded by metal objects, the vehicle
may close and lock with no means of
opening again.
Remove any additional Smart
Keys
from the vehicle before locking.
Note: The fuel filler flap can be opened only when the alarm is disarmed.
READ NEXT:
Lock confirmation
If you are uncertain whether the vehicle is
locked and armed (either by single or double
locking), press either the Smart Key lock
button or, if Keyless entry is fitted, touch an
exterior door han
Single locking
Single locking secures the vehicle and prevents
the doors from being opened from outside. The
doors may still be unlocked and opened using
the interior door locks and release levers. In
this state
Double locking
Never double lock the vehicle
with
people, children, or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quic
SEE MORE:
Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when
traction devices are fitted.
Never fit traction devices to a
temporary use spare wheel.
Land Ro
Label locations
Warning labels attached to your
vehicle bearing this symbol mean: Do
not touch or adjust components until
you have read the relevant
instructions in the handbook.
Labels showing this symbol indicate
that the ignition system utilises very
high voltages. Do not touch any
ignition component
