Ford Escape: Jump starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Connecting the jumper cables
Note: In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
1. Connect the positive (+) jumper
cable to the positive (+) terminal of
the discharge ...
Removing the jumper cables
Remove the jumper cables in the reverse order that they were
connected.
Note: In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
1. Remove th ...
See also:
Location of the keyless drive antennas
Location of the keyless drive antennas
The keyless drive system has a number of
antennas located at various points in the vehicle.
1 On the tailgate, near the wiper motor
2 Left rear door handl ...
Seat belts
Make sure that all occupants are wearing their seat belts before driving
the vehicle.
■ Correct use of the seat belts
● Extend the shoulder belt so
that it comes fully over the
shou ...
Fog Lamps
The fog lamps control is located on the turn/lane change lever.
Use the fog lamps for better vision in foggy or misty conditions.
FOG (Fog Lamps): Turn the fog lamp
band on the lever to and re ...
