Nissan Rogue: Installing front license plate
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
- License plate bracket
- J-nut 6 2
- Screw 6 2
- Screw grommet 6 2
1. Temporarily place the license plate bracket by aligning the lower part A of it with the lines B on the bumper.
2. Mark the pilot hole points with a felt-tip pen through the holes of the license plate bracket.
3. Remove the license plate bracket.
4. Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit at the marked locations. (Be
sure that the drill only goes through the
fascia, or damage to the nut may
occur.)
5. Insert grommets into the hole on the fascia.
6. Insert a flat-blade screwdriver into the grommet hole to add 908 turn onto the part C .
7. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia.
8. Install the license plate bracket with screws.
9. Install the license plate with bolts that are no longer than 0.55 in (14 mm).
Air conditioner specification label
The air conditioner specification label is attached to the underside of the hood as shown. ...Vehicle loading information
- It is extremely dangerous to ride in a cargo area inside the vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. - Do not allow peopl ...See also:
Warranties for your Hyundai vehicle
Please consult your Owner's Handbook &
Warranty Information booklet for your
vehicle's specific warranty coverage. ...
Notes on regularly inspecting wheels and tires
WARNING
Regularly check the tires for damage. Damaged tires can cause tire inflation
pressure loss. As a result, you could lose control of your vehicle.
Worn, old tires can cause accidents. I ...
Brake/Clutch fluid
Brake and clutch (if equipped) systems are supplied from the same
reservoir.
The fluid level will drop slowly as the
brakes wear, and will rise when the
brake components are replaced. Fluid
lev ...