Mercedes-Benz GLK-Class: Hill start assist - Pulling away - Driving - Driving and parking - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Hill start assist

Hill start assist helps you when pulling away forwards or in reverse on an uphill gradient. It holds the vehicle for a short time after you have removed your foot from the brake pedal. This gives you enough time to move your foot from the brake pedal to the accelerator pedal and depress it before the vehicle begins to roll.

WARNING WARNING

Never leave the vehicle when it is held by hill start assist. After approximately one second, hill start assist will no longer brake your vehicle and it could roll away.

  • Take your foot off the brake pedal.

around one second. Once you have taken your foot off the brake pedal, the vehicle is held for around one second.

  • Pull away.

Hill start assist will not function if:

  • you are pulling away on a level road or a downhill gradient.
  • the transmission is in position N.
  • the parking brake is applied.
  • ESP® is malfunctioning.
    Automatic transmission
    WARNING It is dangerous to shift the automatic transmission out of parking position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly on the b ...

    Problems with the engine
    Problem The engine does not start. The starter motor can be heard. Possible causes/consequences and Solutions There is a malfunction in the engine electronics. There is a malfunction in the fu ...

    See also:

    Removing and Replacing the Floor Mat
    The driver side floor mat is held in place by two retainers. 1. Pull up on the rear of the floor mat to unlock each retainer and remove. 2. Reinstall by lining up the floor mat retainer openings o ...

    Battery
    - Before beginning work on or near any battery, be sure to extinguish all cigarettes, matches, and lighters. Never expose a battery to an open flame or electric sparks. Batteries give off ...

    Selecting phone
    To select the registered cell phone for connecting to the in-vehicle equipment, perform the following procedure. 1. Select the “SELECT PHONE” menu. If no cell phones are registered, “EMPT ...