Range Rover Evoque: Garage door opener
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener
- Garage door transceiver
- Before programming
- Programming
- Rolling code device equipment programming
- Reprogramming a single garage door opener button
- To erase all programming
- Entry gate programming
- Information and assistance
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
SEE MORE:
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
Timed climate remote control
The dedicated remote control has a range of
approximately 100m (328ft). Press and hold
the ON button for two seconds.
Note: Avoid touching the antenna when
operating the ON or OFF button.
Timed climate remote control
1. On button.
2. Off button.
3. LED (operation indicator).
4. Antenna.
© 2011-2024 Copyright www.rrevoque.org
