GMC Terrain: Fuel Gauge - Warning Lights, Gauges, and Indicators - Instruments and Controls - GMC Terrain Owner's ManualGMC Terrain: Fuel Gauge

Metric

Metric

English

English

When the ignition is on, the fuel gauge shows about how much fuel the vehicle has left in the fuel tank. An arrow on the fuel gauge indicates the side of the vehicle the fuel door is on.

The gauge will first indicate empty before the vehicle is out of fuel and the low fuel light comes on, but the vehicle's fuel tank should be filled soon.

Here are some situations that can occur with the fuel gauge. None of these indicate a problem with the fuel gauge.

○ At the service station, the fuel pump shuts off before the gauge reads full.
○ It takes a little more or less fuel to fill up than the gauge indicated. For example, the gauge may have indicated the tank was half full, but it actually took a little more or less than half the tank's capacity to fill the tank.
○ The gauge moves a little while turning a corner or speeding up.
○ The gauge takes a few seconds to stabilize after the ignition is turned on, and goes back to empty when the ignition is turned off.

    Tachometer
    The tachometer displays the engine speed in revolutions per minute (rpm). ...

    Engine Coolant Temperature Gauge
    Metric English This gauge measures the temperature of the vehicle's engine. If the indicator needle moves to the hot side of the gauge toward the colored line, the engine is too hot. If ...

    See also:

    Electronic compass (if equipped)
    The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...

    Trailer sway control (if equipped)
    Your vehicle may be equipped with trailer sway control (TSC). When properly equipped, trailer sway control will use the sensors of the vehicle’s AdvanceTrac with RSC system to detect and attempt t ...

    To increase the speed (by button)
    To increase the speed (by button) Push the “RES/ACC” button and hold it until the vehicle reaches the desired speed. Then, release the button. The vehicle speed at that moment will be ...