Jeep Liberty: Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord.
The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
After Starting
The idle speed will automatically decrease as the engine
warms up. ...
Automatic Transmission
CAUTION!
Damage to the transmission may occur if the following
precautions are not observed:
• Shift into PARK only after the vehicle has come to
a complete stop.
• Shift into or out of RE ...
See also:
Definition of terms for tires and loading
Tire ply composition and material used
Describes the number of plies or the number of layers of rubber-coated fabric
in the tire tread and sidewall. These are made of steel, nylon, polyester and ot ...
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
...
Folding the grid up/down
Grasp the lowering edge of the grid and pull it
rearward/upward, or push it downward/forward.
NOTE
If the steel grid is to be used with the
optional cargo area cover, the grid must be
folded d ...
