Dodge Nitro: Engine block heater
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
• The engine block heater cord is found under the hood
clipped to the heater line on the left side of the engine.
WARNING: Remember to disconnect the cord before driving. Damage to the 110-115 Volt AC electrical cord could cause electrocution.
Use the heater when temperatures below 0 °F (-18 °C) are expected to last for several days.
Starting procedures
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING:
Never leave children alone in a vehicle. Leaving
children in a vehic ...
Automatic transmission
CAUTION:
Damage to the transmission may occur if the following
precautions are not observed:
• Shift into PARK only after the vehicle has come to
a complete stop.
• Shift into or out of ...
See also:
Important safety notes
WARNING
The following factors increase the risk of accidents:
Excessive speed, especially in turns
Wet and slippery road surfaces
Following another vehicle too closely
The driving saf ...
Keyless drive information messages
If all of the PCCs are removed from the vehicle
while the engine is running or if the ignition is
in mode II (see page 82) and all of the doors
are closed, a message will appear in the instrumen ...
Wiper operation when snowing
Before driving in cold weather, make sure
the wiper blades are not frozen to the
windshield or rear window.
If the wiper blades are frozen to the
windshield or rear window, perform the
follow ...
