Jeep Liberty: Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch located in the switch bank of the instrument panel or through the Customer-Programmable Features section of the EVIC. The available choices are: OFF, Sound Only, or Sound and Display. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)” in “Understanding Your Instrument Panel” for further information.
When the ParkSense switch is pressed to disable the system, the instrument cluster will display the “PARK ASSIST OFF” message for approximately five seconds. Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information. When the shift lever is moved to REVERSE and the system is disabled, the EVIC will display the “PARK ASSIST OFF” message for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be ON when Park- Sense is disabled or defective. The ParkSense switch LED will be OFF when the system is enabled.
Parksense Display
When the vehicle is in REVERSE, the warning display will turn ON indicating the system status. Park Assist ON Park Assist Off The system will indicate a detected obstacle by showing three s ...Service The Parksense Rear Park Assist System
When the ParkSense Rear Park Assist System is malfunctioning, the instrument cluster will actuate a single chime, once per ignition cycle, and it will display the “SERVICE PARK ASSIST SYSTEM ...See also:
Suggestions for obtaining service for your vehicle
Prepare For The Appointment
If you’re having warranty work done, be sure to have the
right papers with you. Take your warranty folder. All
work to be performed may not be covered by the
warra ...
Overview: changing bulbs/bulb types
You can change the following bulbs. The bulb type can be found in the legend.
Halogen headlamps
Turn signal lamp/side marker lamp: WY 5 W
Turn signal lamp: PY 21 W
High-beam headlamp: H7 55 ...
Adjusting the Sound
You can adjust the sound on the
navigation screen. To adjust the
sound, push the AUDIO button, then
enter the sound grid by touching the
SOUNDicon on the display.
BASS - Adjusts the b ...