Jeep Liberty: Cooling System – Drain, Flush, And Refill
If the engine coolant (antifreeze) is dirty or contains a considerable amount of sediment, clean and flush with a reliable cooling system cleaner. Follow with a thorough rinsing to remove all deposits and chemicals. Properly dispose of the old engine coolant (antifreeze).
Refer to the “Maintenance Schedule” for the proper maintenance intervals.
Engine Coolant Checks
Check the engine coolant (antifreeze) protection every
12 months (before the onset of freezing weather, where
applicable). If the engine coolant (antifreeze) is dirty or
rusty in appearance, the ...
Selection Of Engine Coolant
Use only the manufacturer’s recommended engine coolant
(antifreeze). Refer to “Fluids, Lubricants, and Genuine
Parts” in “Maintaining Your Vehicle” for further
information.
CAUTION!
...
See also:
European declaration of conformity
Hereby, DENSO CORPORATION
declares that this DN-NS-019 is in
compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC. ...
Selecting a magnetic zone
Magnetic zones.
The earth is divided into 15 magnetic zones.
The correct zone must be selected for the compass
to work correctly.
1. Put the ignition in mode II.
2. Using a pen or similar obje ...
Coolant temperature low indicator light (if equipped)/Coolant temperature
high warning light (if equipped)
- After turning the ignition switch
to the “ON” position, if this
indicator light/warning light behaves
under any of the following
conditions, the electrical system
may be malfun ...
