Nissan Rogue: Connecting iPod®
To connect an iPod® to the vehicle so that the iPod® can be controlled with the audio system controls and display screen, use the USB jack located in the center console. Open the protective cover on the USB jack in the center console and then connect the iPod® specific end of the cable to the iPod® and the USB end of the cable to the USB jack on the vehicle 1 .
If your iPod® supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position.
While connected to the vehicle, the iPod® can only be operated by the vehicle audio controls.
To disconnect the iPod® from the vehicle, remove the USB end of the cable from the USB jack on the vehicle, then remove the cable from the iPod®.
* iPod® is a trademark of Apple Inc., registered in the U.S. and other countries.
Compatibility
The following models are available: - Fifth generation iPod® (version 1.2.3 or later) - iPod Classic (version 1.1.1 or later) - First generation iPod touch® (version 2.0.0 or later) - Se ...See also:
Opening
Switch off the engine.
emove the SmartKey from the ignition lock.
KEYLESS-GO: open the driver’s door. This switches the ignition to position 0,
which corresponds to having removed the Smar ...
12-volt sockets
12-volt socket in the front tunnel console
12-volt socket in the rear center console
The electrical sockets can be used for 12-volt
accessories such as cell phone chargers and
coolers. For t ...
Transporting the vehicle
The towing eyes or trailer tow hitch can be used to pull the vehicle onto a trailer
or transporter if you wish to transport it.
Turn the SmartKey to position 2 in the ignition lock.
Shift the ...