Ford Escape: Compass zone adjustment - Electronic compass (if equipped) - Driver Controls - Ford Escape Owner's ManualFord Escape: Compass zone adjustment

1. Determine which magnetic zone you are in for your geographic location by referring to the zone map.
2. Turn ignition to the on position.
3. Start the engine.

4. Press the SETUP control to select

4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.

5. Continue to press the RESET

5. Continue to press the RESET control until the correct zone appears in the center stack display.

6. The direction will display after

6. The direction will display after the RESET control is released. The zone is now updated.

Compass calibration adjustment

    Electronic compass (if equipped)
    The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...

    Compass calibration adjustment
    Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) an ...

    See also:

    Voicetags
    Voicetags enable the user to personalise the Voice system so that a single name can be used to call-up a navigation destination, telephone number or radio channel. To add a Voicetag: 1. Briefly p ...

    Activating the system
    Before any phone voice commands can be used, a Bluetooth®-enabled cell phone must be paired with the infotainment system. If a phone command is given, the system will inform you If there is n ...

    Audio main operation
    Place the ignition switch in the ACC or ON position. Then, push the button repeatedly to switch to the iPod® mode. If the system has been turned off while the iPod® was playing, pushing the O ...