Nissan Rogue: Clearing the programmed information - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Clearing the programmed information

Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).

    Programming trouble-diagnosis
    If HomeLink® does not quickly learn the handheld transmitter information: - replace the hand-held transmitter batteries with new batteries. - position the hand-held transmitter with its batt ...

    Reprogramming a single HomeLink® button
    To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. Wh ...

    See also:

    Things you need to know
    Operate the system only when it is safe to do so. The requirements of national Road Traffic Regulations always apply. Observation of traffic signs and local traffic regulations always take pri ...

    Towing the vehicle with the rear axle raised
    Only possible on vehicles without 4MATIC. When towing your vehicle with the rear axle raised, it is important that you observe the safety instructions (). The ignition must be switched off if y ...

    Air inlet selection button
    Air inlet selection button ON position (Recirculation): Interior air is recirculated inside the vehicle. Push the air inlet selection button to the ON position. The indicator light will illu ...