Nissan Rogue: Checking engine oil level - Engine oil - Maintenance and do-it-yourself - Nissan Rogue Owner's ManualNissan Rogue: Checking engine oil level

1. Park the vehicle on a level surface and apply

1. Park the vehicle on a level surface and apply the parking brake.

2. Run the engine until it reaches operating temperature.

3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dipstick and wipe it clean.

Reinsert it all the way.

5. Remove the dipstick again and check the oil level. It should be within the range 1 . If the oil level is below 2 , remove the oil filler cap and pour recommended oil through the opening. Do not overfill 3 .

6. Recheck oil level with the dipstick.

It is normal to add some oil between oil maintenance intervals or during the breakin period, depending on the severity of operating conditions.

Oil level should be checked regularly.

Oil level should be checked regularly.

Operating the engine with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty.

    Changing engine oil and filter
    Change the engine oil and filter according to the maintenance log shown in the NISSAN Service and Maintenance Guide. ...

    See also:

    Shift Positions
    The transfer case switch is located on the center console next to the shift lever. Transfer Case Switch 2WD Rear Wheel Drive High Range - This range is for normal street and highway driving o ...

    Active chassis (Four C)
    Active chassis, Four-C (Continuously Controlled Chassis Concept), regulates the characteristics of the shock absorbers so that the car's driving characteristics can be adjusted. There are three ...

    Exterior front
    Exterior front 1. Front view camera* 2. Hood 3. Headlight and turn signal lights — Switch operation — Bulb replacement 4. Windshield wiper and washer — Switch operation — Blad ...