Subaru Forester: Channel scan - Channel and category selection - Satellite radio operation (if equipped) - Audio - Subaru Forester Owner's ManualSubaru Forester: Channel scan

Press the “SCAN” button briefly (type A, B

Press the “SCAN” button briefly (type A, B and C audio)/for more than 1.5 seconds (type D audio) to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. The radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end.

Press the “SCAN” button briefly (type A, B and C audio)/for more than 1.5 seconds (type D audio) again to cancel the SCAN mode and to stop on any displayed channel.

    Type D audio
    When in the SAT mode, press the button to change the category search mode. When in the category search mode, press the following button to change the category up or down. When a category ...

    See also:

    Storing the ball coupling
    WARNING Do not carry the ball coupling in the vehicle interior if it is not secured. Otherwise, you and others could be injured by the ball coupling being thrown around if you: brake shar ...

    Illuminated Entry
    The courtesy lights will turn on when you use the Remote Keyless Entry (RKE) transmitter to unlock the doors or open any door. This feature also turns on the approach lighting in the outside mi ...

    System fault
    If a system fault is detected, a long high-pitched tone will sound and the switch indicator will flash. A message will be displayed in the message centre. Contact your Dealer/ Authorised Repairer ...