Mercedes-Benz GLK-Class: Calibrating the compass
- Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.
In order to calibrate the compass correctly, observe the following points:
- calibrate the compass in the open and not in the vicinity of steel constructions or highvoltage transmission lines.
- switch off electrical consumers, for example, the climate control, windshield wipers or rear window defroster.
- close all doors and the tailgate.
- Switch the ignition on.
- Press a round pin into opening 3() for approximately six seconds until the C symbol appears in compass display 2().
- Drive a full circle at approximately 3 mph (5 km/h) to 6 mph (10 km/h). Once the calibration has been successfully completed, the current direction appears in compass display 2().
Setting the compass
Determine your position using the following zone maps.
North America zone map
South America zone map
Press a round pin into opening 3() for approximately three seconds.
The currently ...
Floormat on the driver's side
WARNING
Whenever you are using a floormat, make sure there is enough clearance and that
the floormat is securely fastened.
The floormat should always be securely fastened using the fastening ...
See also:
Cancel Command
At any prompt, after the beep, you can say “Cancel” and
you will be returned to the main menu. However, in a
few instances the system will take you back to the
previous menu. ...
Error codes
If an error code (1) appears in the display, take action in accordance with the
table below.
...
Fuses
Fuse block location
To prevent damage to the electrical system due to shortcircuiting or overloading,
each individual circuit is provided with a fuse. There are fuse blocks in the passenger
compa ...
