Hyundai Tucson: Before starting the engine - Driving your Hyundai - Hyundai Tucson Owner's ManualHyundai Tucson: Before starting the engine

Before you start the engine, you should always: 1. Look around the vehicle to be sure there are no flat tires, puddles of oil, water or other indications of possible trouble. 2. After entering the car, check to be sure the parking brake is engaged. 3. Check that all windows, and lights are clean. 4. Check that the interior and exterior mirrors are clean and in position. 5. Check your seat, seatback and headrest to be sure they are in their proper positions. 6. Lock all the doors. 7. Fasten your seat belt and be sure that all other occupants have fastened theirs. 8. Turn off all lights and accessories that are not needed. 9. When you turn the ignition switch to "ON", check that all appropriate warning lights are operating and that you have sufficient fuel. 10.Check the operation of warning lights and all bulbs when key is in the "ON" position.

WARNING: o All passengers must be properly belted whenever the vehicle is moving. o Always check the surrounding areas near your vehicle for people, especially children, before putting a car into 'drive.'

WARNING: Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots, etc.) may interfere with your ability to use the brake and accelerator pedal, and the clutch (if installed).

    WARNING: When you intend to park or stop the vehicle with the engine on, be careful not to depress the accelerator pedal for a long period of time. It may overheat the engine or exhaust system and cause fire.

    Risk of rollover
    WARNING: o The 2WD Tucson is not designed for offroad use. The 4WD Tucson is designed primarily for use on paved roads. However, occasional use in off-highway conditions such as established ...

    To start the engine
    COMBINATION IGNITION SWITCH o If your Hyundai is equipped with a manual transaxle, place the shift lever in neutral and depress the clutch pedal fully. o If your Hyundai has an automatic transa ...

    See also:

    Steps for Determining Correct Load Limit
    1. Locate the statement "the combined weight of occupants and cargo should never exceed XXX pounds" on your vehicle's placard. 2. Determine the combined weight of the driver and pas ...

    Moisture
    Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle, and should be removed for drying to ...

    Cleaning the display
    Before cleaning the display, make sure that it is switched off and has cooled down. Clean the display surface using a commercially-available microfiber cloth and TFT/LCD display cleaner. ...