Nissan Rogue: Battery saver system - Headlight switch - Headlight and turn signal switch - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Battery saver system

- When the headlight switch is in the position while the ignition switch is in or position while the ignition switch is in position while the ignition switch is in the ON position, the lights will automatically turn off 5 minutes after the ignition switch has been turned to the OFF position.

- When the headlight switch remains in the position or after the lights automatically position after the lights automatically turn off, the lights will turn on when the ignition switch is turned to the ON position.

- When you turn on the headlight

- When you turn on the headlight switch again after the lights automatically turn off, the lights will not turn off automatically. Be sure to turn the light switch to the OFF position when you leave the vehicle for extended periods of time, otherwise the battery will be discharged.

- Never leave the light switch on when the engine is not running for extended periods of time even if the headlights turn off automatically.

    Headlight beam select
    Headlight beam select 1 To select the low beam, put the lever in the neutral position as shown. 2 To select the high beam, push the lever forward while the switch is in the position. Pull it ...

    Headlight aiming control (if so equipped)
    Headlight aiming control (if so equipped) Depending on the number of occupants in the vehicle and the load it is carrying, the headlight axis may be higher than desired. If the vehicle is tra ...

    See also:

    Service precautions
    Adequate care of your vehicle at regular intervals serves to preserve the value and appearance as long as possible. Maintenance items as described in this owner’s manual can be performed by the ...

    Data stored in the vehicle
    Information about electronic data acquisition in the vehicle (Including notice pursuant to California Code § 9951) Your vehicle records electronic data. If your vehicle is equipped with mbrace1, ...

    To arm the system using remote transmitter
    1. Close all windows and the moonroof (if equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. ...