Nissan Rogue: Antenna
Antenna
To remove the antenna, hold the bottom of the antenna and turn it counterclockwise.
To install the antenna, turn the antenna clockwise and tighten.
- To avoid damaging or deforming the antenna, be sure to remove the antenna under the following conditions.
— The vehicle enters an automatic car wash.
— The vehicle enters a garage with a low ceiling.
— The vehicle is covered with a car cover.
- Always properly tighten the antenna rod during installation. Otherwise, the antenna rod may break during vehicle operation.
VOLUME control switch
Push up or down the VOLUME control switch to increase or decrease the volume. Tuning switch Memory change (radio): Push up or down the tuning switch for less than 1.5 seconds to change the ne ...Car phone and CB radio
When installing a car phone or a CB radio in your vehicle, be sure to observe the following cautions, otherwise the new equipment may adversely affect the electronic control modules and electr ...See also:
Precautions against vehicle modification
To avoid accidental activation of the
system or rendering the system
inoperative, which may result in
serious injury, no modifications
should be made to any components
or wiring of the S ...
Navigating and playing tracks
Turn TUNE to access the device's playlist and
to navigate in this list. Press OK/MENU to
either select a sub-folder or confirm a choice
and begin playback. Press EXIT to cancel and
exit the pl ...
Driving tips
Do not drive with your foot resting on the
clutch pedal and do not use the clutch to
hold your vehicle at a standstill on an
upgrade. Either of those actions may
cause clutch damage.
Do not d ...