Jeep Liberty: Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prematurely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — L/Gate Ajar
• Remote Start Aborted — System Fault
• Remote Start Aborted — Fuel Low
The EVIC message stays active until the ignition is turned to the ON/RUN position.
How To Use Remote Start
All of the following conditions must be met before the engine will remote start: • Shift lever in PARK. • Doors closed. • Hood closed. • Liftgate closed. • Hazard switch off. â ...To Enter Remote Start Mode
Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...See also:
Seatbelt warning light and chime
Your vehicle is equipped with a seatbelt
warning device at the driver’s and front
passenger’s seat, as required by current
safety standards.
With the ignition switch turned to the “ON ...
Maintenance precautions
When maintenance and service are required,
it is recommended that all work be
done by an authorized SUBARU dealer.
If you perform maintenance and service
by yourself, you should familiarize you ...
Pairing
A Bluetooth&-enabled cell phone must be paired to the Bluetooth system and then
connected to the vehicle before it can be used. See your cell phone manufacturer's
user guide for Bluetooth ...