Hyundai Tucson: Air cnditioning care
Keeping the Condenser Clean
The air conditioning condenser (and engine radiator) should be checked periodically for accumulation of dirt, dead insects, leaves, etc. These can interfere with maximum cooling efficiency. When removing such accumulations, brush or hose them away carefully to avoid bending the cooling fans.
Checking the Air Conditioning Operation
1. Start the engine and let it run at a fast idle for several minutes with the air conditioning set at the maximum cold setting. 2. If the air coming out of the in-dash vents is not cold, have the air conditioning system inspected by your Hyundai dealer.
CAUTION: Running the air conditioning system for extended periods of time with a low refrigerant level may damage the compressor.
Lubrication
To lubricate the compressor and the seals in the system, the air conditioning should be run for at least 10 minutes each week. This is particularly important during cool weather when the air conditioning system is not otherwise in use.
Checking the Compressor Drive Belt
When the air conditioning is being used regularly, the compressor drive belt tension should be checked at least once a month with the engine turned off. To check the drive belt tension, press down on the belt halfway between the engine crankshaft and compressor pulleys. Pressing with your finger, you should not be able to deflect this belt anymore than 1/3 of an inch. If the belt is too loose, have it adjusted by your Hyundai dealer.
Checking the clutch fluid
To Check the Clutch Fluid The clutch fluid level in the master cylinder should be checked when performing other under hood services. The system should be checked for leakage at the same time ...Changing the climate control air filter
(For Evaporator and Blower Unit) (If Installed) The climate control air filter is located in front of the evaporator unit behind the glove box. It helps to decrease the amount of pollutants e ...See also:
Automatic Door Locks — If Equipped
The auto door lock feature default condition is disabled.
When enabled, the door locks will lock automatically
when the vehicle’s speed exceeds 15 mph (24 km/h). The
auto door lock feature can ...
To use as full-automatic climate control system
1. Place the temperature control dial in
the position for the preferred temperature.
2. Set the airflow control dial and fan
speed control dial in the “AUTO” position.
The system’s functio ...
Starting your vehicle
Starting your vehicle
The remote control start system is activated
by pressing the “” button twice
within 3 seconds on your remote control
transmitter. The system will check certain
p ...