Mercedes-Benz GLK-Class: Activating/deactivating the residual heat function
It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.
The blower will run at a low speed regardless of the airflow setting.
If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.
It is possible that the residual heat function may be activated automatically an hour after the SmartKey is removed. The vehicle is then ventilated for 30 minutes to dry the air-conditioning system.
- Turn the SmartKey to position 0 in the ignition lock or remove it.
- To activate: press the button. The indicator lamp in the button lights up.
- To switch off: press the button. The indicator lamp in the button goes out.
Residual heat is deactivated automatically:
- after about 30 minutes
- when the ignition is switched on
- if the battery voltage drops
- if the coolant temperature is too low
Activating/deactivating airrecirculation mode
You can deactivate the flow of fresh air if unpleasant odors are entering the vehicle from outside. The air already inside the vehicle will then be recirculated. WARNING Fogged windows impair ...See also:
Rear fog lamp
To switch on the rear fog lamp: turn the SmartKey in the ignition lock
to position 2 or start the engine.
Turn the light switch to
or or
.
If the light switch is set to or
, the re ...
Operating Instructions (Voice Command System) — If Equipped
Refer to “Voice Command” in the Uconnect™ User
Manual located on the DVD for further details. ...
Valet
Selection:
Valet mode allows the vehicle to be driven and
locked by a parking attendant, without giving
access to the luggage compartment. Valet
mode also prevents operation of the touch
screen, ...