Subaru Forester: ABS warning light
- If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer.
– The warning light does not illuminate when the ignition switch is turned to the “ON” position.
– The warning light illuminates when the ignition switch is turned to the “ON” position, but it does not turn off even when the vehicle speed exceeds approximately 8 mph (12 km/h).
– The warning light illuminates during driving.
- When the warning light is on (and the brake system warning light is off), the ABS function shuts down. However, the conventional brake system continues to operate normally.
With a vehicle equipped with an EBD system, the ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system malfunction warning, refer to “Brake system warning light”.
NOTE
If the warning light behavior is as
described in the following items, the
ABS system may be considered normal.
- The warning light illuminates right after the engine is started but turns off immediately, remaining off.
- The warning light remains on after the engine has been started, but it turns off when the vehicle speed reaches approximately 8 mph (12 km/h).
- The warning light illuminates during driving, but it turns off immediately and remains off.
When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate.
This is due to the low battery voltage and does not indicate a malfunction.
When the battery becomes fully charged, the light will turn off.
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the
“ON” position, the low tire pressure warning
light will illuminate for approximately 2
seconds to check that the tire pressure
monitoring syst ...
Brake system warning light
- Driving with the brake system
warning light on is dangerous.
This indicates your brake system
may not be working properly. If
the light remains illuminated,
have the brakes inspecte ...
See also:
To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase
speed by pushing the RES (+) button. If the button
is continually pressed, the set speed will continue to
increase until the button is ...
Automatic interior lighting control
To switch on/off: press the | button. When the automatic interior lighting control
is activated, the button is flush with the overhead control panel.
The interior lighting automatically switches on ...
Parking brake
WARNING
Engaging the parking brake while the vehicle is in motion can cause the rear
wheels to lock up. You could lose control of the vehicle and cause an accident.
In addition, the vehicle& ...
