Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Glass

Component Location Index WINDSHIELD MOLDING MOLDING UPPER SEAL UPPER RUBBER DAM CLIP, 2 WINDSHIELD SIDE TRIM SIDE RUBBER DAM WINDSHIELD RETAINER,8 QUARTER GLASS MOLDING CLIP, 1 CLIP, 2 QUARTER GLASS ULEV STICKER FRONT SEAL UPPER RUBBER DAM UPPER FASTENER 2 FASTENER 2 LOW

 DTC P2135: TP Sensor A/B Voltage Incorrect Correlation

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated. NOTE: Before you troubleshoot, record all freeze data and any o

© 2016-2024 Copyright www.hcrv.net