Range Rover Evoque: Window reset
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Windows / Window reset
If the battery is disconnected or the power supply is interrupted, the windows must be reset.
Once the power supply is restored, reset as follows: 1. Close the window fully.
2. Release the switch, then lift it to the close position and hold for 1 second.
3. Repeat the procedure on each window.
READ NEXT:
Anti-trap protection
Closing a window or roof
blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a posi
Resonance with lowered windows
if a resonance or booming sound occurs when
a rear window is open, lowering an adjacent
front window by approximately 25mm (1 inch)
will eliminate the condition.
SEE MORE:
Rear Lamp Mounting Panel
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.
Side Panel Dimensions
3-door version
5-d
© 2011-2024 Copyright www.rrevoque.org
