Range Rover Evoque: Voicetags
Voicetags enable the user to personalise the Voice system so that a single name can be used to call-up a navigation destination, telephone number or radio channel.
To add a Voicetag: 1. Briefly press the Voice button to start a Voice session.
2. Wait for the tone to sound then say Phone, Navigation or Radio.
3. Say Store voicetag.
Alternatively, Voicetags can be managed via the touch screen as follows.
1. Select Setup from the Home menu.
2. Select Voice from the Setup menu.
3. Select Voicetags from the Voice settings menu.
4. Select the system which the Voicetag is to activate (Phone, Navigation or Radio).
Follow the on-screen and audible instructions.
READ NEXT:
Navigation poi voice commands
To request the display of POI (Point Of Interest)
identifiers on the navigation display:
- Say Navigation, followed by the name of
the desired P.O.I category from the
following list;
- Petrol sta
Bluetooth® information
Bluetooth® is the name for
short-range radio frequency (RF)
technology that allows electronic
devices to communicate wirelessly with each
other.
The Land Rover Bluetooth® system supports
Blu
SEE MORE:
Desiccant Bag GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control,
Removal and Installation).
3. Torque: 11 Nm
Installation
1
Wiring Harness - Description and Operation
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
© 2011-2024 Copyright www.rrevoque.org
