GMC Terrain: Turn and Lane-Change Signals
An arrow on the instrument panel cluster will flash in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is complete. If the lever is briefly pressed and released, the turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or a lane change the arrows flash rapidly or do not come on, a signal bulb may be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse; see Fuses on page 10‑38 for more information.
Hazard Warning Flashers
(Hazard Warning Flasher): Press
this button, on the center of the instrument panel, to make the front and rear turn
signal lamps flash on and off. This warns others that you are having trouble. ...
Fog Lamps
The fog lamps control is located on the turn/lane change lever.
Use the fog lamps for better vision in foggy or misty conditions.
FOG (Fog Lamps): Turn the fog lamp
band on the lever to and re ...
See also:
System fault
If a system fault is detected, a long
high-pitched tone will sound and the switch
indicator will flash. A message will be displayed
in the message centre. Contact your Dealer/
Authorised Repairer ...
Land rover tyre repair kit
Land rover tyre repair kit
1. Maximum speed label. 80 km/h (50 mph).
2. Tyre inflation hose.
3. Inflation hose protective cap.
4. Inflation hose connector.
5. Compressor power cable.
6. Power ...
Inspecting your tires and wheel valve stems
Periodically inspect the tire treads for uneven or excessive wear and
remove objects such as stones, nails or glass that may be wedged in the
tread grooves. Check the tire and valve stems for holes, ...
