Range Rover Evoque: To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).

2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.

All memories in HomeLink have now been cleared.

Note: Do not perform this procedure when programming the additional garage door opener buttons.

READ NEXT:

 Entry gate programming

The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programming. Continue to press and hold the desired HomeLin

 Information and assistance

It is recommended that when you sell or dispose of the vehicle, the programmed HomeLink buttons be erased for security purposes. For information on the range of available compatible products or

 Instrument panel

Instrument panel 1. Speedometer. 2. Driver Information Centre (message centre). 3. Tachometer. 4. Temperature gauge Serious engine damage can occur if the vehicle is driven while the engin

SEE MORE:

 Vehicle Transportation Aids and Vehicle Storage

New Vehicle Storage INTRODUCTION Standards Vehicles may require storage for varying periods of time before the customer takes delivery. It is essential that a new Land Rover vehicle is stored correctly, in order to ensure total customer satisfaction after the car is removed from storage and prepar

 Desiccant Bag GTDi 2.0L Petrol

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation). 3. Torque: 11 Nm Installation 1

© 2011-2024 Copyright www.rrevoque.org