Range Rover Evoque: Tilt sensor
The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alarm.
Note: The tilt sensors can be temporarily disabled for the next time the vehicle is locked.
See Alarm Sensors, 56, VEHICLE INFORMATION AND SETTINGS MENU. The sensors will be automatically enabled the next time the vehicle is double locked with the Smart Key.
READ NEXT:
Door lock and release levers
Door lock and release levers
1. Press a locking lever to lock a door. Pull the
lever back to unlock. Operating either front
door locking levers will lock or unlock all
doors.
2. Pull a release
Manual seats
Manual seats
Do not adjust
the seat while the
vehicle is moving. Doing so could
cause loss of vehicle control and
personal injury.
1. Forward and back adjustment.
2. Height adjustment.
3.
SEE MORE:
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
1. Disconne
Epb automatic use
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EPB
switch in the release position. Within 5
seconds, switch off the ignition and continue to
hold
© 2011-2024 Copyright www.rrevoque.org
