Toyota RAV4: Switching the door unlock function
It is possible to set which doors the entry function unlocks.
1 Turn the “ENGINE START STOP” switch OFF.
2 When the indicator on the key surface is turned off, push and hold
for approximately 5 seconds
while pushing
on the key.
The setting changes each time an operation is performed, as shown below. (When changing the setting continuously, release the buttons, wait for at least 5 seconds, and repeat step 2.)
Conditions affecting operation
The smart key system uses weak radio waves. In the following situations,
the communication between the electronic key and the vehicle may be
affected, preventing the smart key system and wireless re ...
Battery-saving function
In the following circumstances, the entry function is disabled in order to
prevent
the vehicle and electronic key batteries from discharging.
●When the entry function has not been used for 2 ...
See also:
Most common factors contributing to vehicle corrosion
- The accumulation of moisture-retaining dirt
and debris in body panel sections, cavities,
and other areas.
- Damage to paint and other protective coatings
caused by gravel and stone chips or
...
Seat-mounted side airbag system
WARNING: Do not place objects or mount equipment on or
near the airbag cover on the side of the seatbacks of the front
seats or in front seat areas that may come into contact with a
deploying airb ...
Starting the engine
1. Turn the key to 3 (on) without
turning the key to 4 (start). If there
is difficulty in turning the key,
rotate the steering wheel until the
key turns freely. This condition may
occur when:
...
