Ford Escape: Switching off traction control
If the vehicle is stuck in snow, mud or sand, and seems to lose engine power, switching off the traction control features of the AdvanceTrac with RSC system may be beneficial because the wheels are allowed to spin. This will restore full engine power and will enhance momentum through the obstacle. To switch off the traction control, press the traction control off button. Full features of the stability control system can be restored by pressing the traction control off button again, or by turning off and restarting the engine.
If you switch off the traction control, the stability control “OFF” light will illuminate steadily. Pressing the stability control off button again will turn off the stability control “OFF” light.
In R (Reverse), ABS and the engine and brake traction control features will continue to function; however, ESC and RSC are disabled.
1 When the AdvanceTrac button is pressed momentarily, traction control is disabled.
2 When the AdvanceTrac button is pressed and held for more than five seconds, trailer sway control is disabled.
Roll Stability Control™ (RSC)
Roll Stability Control (RSC ) may help to maintain roll stability of the
vehicle during adverse maneuvers. RSC operates by detecting the
vehicle’s roll motion and the rate at which it changes and ...
Trailer sway control (if equipped)
Your vehicle may be equipped with trailer sway control (TSC). When
properly equipped, trailer sway control will use the sensors of the
vehicle’s AdvanceTrac with RSC system to detect and attempt t ...
See also:
Activating RSE
The RSE system can be activated using controls
on the front or rear screens.
From the front seat, press MEDIA (see the following
illustration) and select RSE.
From the rear seat, press the scree ...
Head restraint adjustment
Both the rear window side seats and the
rear center seat are equipped with head
restraints.
- Never drive the vehicle with the
head restraints removed because
they are designed to reduce ...
System setup
You can select the following menus only
by operating the “TUNE/TRACK/CH” dial. ...
