Subaru Forester: Starting the engine
Do not operate the starter motor continuously for more than 10 seconds.
If the engine fails to start after operating the starter for 5 to 10 seconds, wait for 10 seconds or more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnected
and reconnected (for maintenance
or other purposes). This difficulty
is caused by the electronically
controlled throttle’s self-diagnosis
function. To overcome it, keep the
ignition switch in the “ON” position
for approximately 10 seconds before
starting the engine.
Preparing to drive
You should perform the following checks
and adjustments every day before you
start driving.
1. Check that all windows, mirrors, and
lights are clean and unobstructed.
2. Check the appearance a ...
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Press the clutch pedal to the floor and
shift the shift lever into neutral. Hold the
clutch pedal to the floor whil ...
See also:
Positioning a floor jack
When raising your vehicle with a floor jack, position the jack correctly.
Improper placement may damage your vehicle or cause injury.
■ Front
■ Rear
CAUTION
■When raising yo ...
Fuel-filler cap
Fuel-filler cap
To remove the fuel-filler cap:
1. Turn the fuel-filler cap counterclockwise to
remove.
2. Put the fuel-filler cap on the cap holder A
while refueling.
To install the fuel-fi ...
Error Messages
If Disc Error displays and/or the disc comes out, it could be for one of the
following reasons:
○ The disc has an invalid or unknown format.
○ The disc is very hot. Try the disc again ...
