Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
Replacing remote control batteries

With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.

READ NEXT:

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

 Cup holders and storage

Cup holders and storage 1. Glovebox. 2. Inside the glovebox is a drop down storage area for the Owner’s Handbook pack. 3. Cubby box. 4. Sliding top to reveal cup holders. Do not drink, or u

SEE MORE:

 Transmission Fluid Pan GTDi 2.0L Petrol

Removal CAUTION: Extreme cleanliness must be exercised when handling this component. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Eng

 Parking Brake and Actuation

Parking Brake - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. COMPONENT LOCATION ABS (anti-lock brake system) module Instrument cluster EPB (electronic parking brake) switch RH (right-hand)EPB actuator LH (left-hand)EPB actuat

© 2011-2024 Copyright www.rrevoque.org