Nissan Rogue: Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener components.
Programming HomeLink®
To program your HomeLink® Transceiver to
operate a garage door, gate, or entry door
opener, home or office lighting, you need to be
at the same location as the device. Note:
Garage door opene ...
Operating the HomeLink® Universal Transceiver
HomeLink Universal Transceiver (once programmed)
may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink® Universal
Transceiver button. T ...
See also:
Ashtray in the rear-compartment center console
To open: pull cover 2 out by its top edge.
To remove the insert: press release button 3 and lift the insert up and
out.
To install the insert: install insert 1 from above into the holder a ...
Head restraints
Head restraints supplement the other
vehicle safety systems. They may provide
additional protection against injury
in certain rear end collisions. Adjust the
head restraints properly, as spe ...
Sound controls and audio settings
NOTE
- SPEED VOLUME CONTROL is a
function that automatically adjusts the
volume according to the vehicle speed.
As the vehicle speed increases, the
audio volume automatically increases
to m ...
