Mercedes-Benz GLK-Class: Preparing the cargo net
The cargo net can be used in two different positions (behind the B-pillar or the C-pillar).
- The brackets behind B-pillar : are required for the cargo compartment enlargement (). The corresponding cargo tie down rings to tighten the net are located in the footwell of the rear bench seat ().
- The brackets behind C-pillar ; are required for the cargo compartment behind the rear bench seat.
The corresponding cargo tie down rings to tension the net are located in the cargo compartment ().
The cargo net is located in the loading tray in the stowage well under the trunk floor ().
- Open both Velcro fasteners and remove the cargo net.
- Unroll and unfold the cargo net. The upper and lower guide rods must engage audibly.
Important safety notes
WARNING
Make sure the cargo net is properly engaged at top and bottom position and the
tightening belts are securely fastened.
Never use a damaged cargo net. Always use cargo net when transpo ...
Attaching the cargo net
Cargo net attached behind the C-pillar
Insert guide rod 2 into retainer 1 in the direction of the arrow.
Slide guide rod 2 forwards into retainer 1 in the direction of the arrow.
...
See also:
Opening and closing the side outlets
1 Open the vent.
2 Close the vent.
■Using the system in recirculated air mode
The windows will fog up more easily if the recirculated air mode is used for
an extended period.
■Windo ...
Rolling code programming
Note: Programming the rolling code garage door opener involves
time-sensitive actions. Read the entire procedure prior to beginning so
you will know which actions are time-sensitive. If you do not f ...
Using the system's menus
Selections in the RSE menus are made using
the remote control. See page 251 for more
information about the RSE menus. ...
