Range Rover Evoque: Memory seats
Front seat positions can be saved to vehicle
memory.
Once you have adjusted the power operated
driver’s seat and the exterior mirrors, the
vehicle can memorise the settings for future
use. See 48, EXTERIOR MIRRORS.
1. On the driver’s seat, press the memory
store button to activate the memory
function. The switch indicator will
illuminate.
2. Press one of the preset buttons within 5
seconds to memorise the current settings.
Memory (1, 2 or 3) Settings Saved will be
displayed on the message centre,
accompanied by an audible chime to
confirm the settings have been saved to
memory.
Note: A seat position will be saved to
memory only during the 5 second active
period.
Note: Any existing settings will be
over-written when a new position is saved
to memory.
To recall a saved position, press the
relevant preset button (2). Memory (1, 2 or
3) Recalled will be displayed in the
message centre.
For the passenger seat of a Coupe model,
press the memory button to store the
current settings. If the seat adjustment is
subsequently changed, press the memory
button to restore the original settings.
READ NEXT:
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
Models with ‘sports’ seats have non adjustable
and non removable head restraints.
SEE MORE:
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions must be
followed strictly to avoid any chance of NVH or
failure of the rear seat backrests.
5-door
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
© 2011-2024 Copyright www.rrevoque.org