Nissan Rogue: Making a call by entering a phone number
1. Push the button on steering wheel. A tone will sound.
2. Say: “Call” A . The system acknowledges the command and announces the next set of available commands.
3. Say: “Phone Number” B . The system acknowledges the command and announces the next set of available commands.
Say: “Special Dialing” to dial more than 10 digits or any special characters.
4. Say the number you wish to call starting with the area code in single digit format. If the system has trouble recognizing the correct phone number, try entering the number in the following groups: 3-digit area code, 3- digit prefix and the last 4-digits. For example, 555-121-3354 can be said as “five five five” as the 1st group, then “one two one” as the 2nd group, and “three three five four” as the 3rd group. For dialing more than 10 digits or any special characters, say “Special Dialing”.
See “How to say numbers” earlier in this section, for more information.
5. When you have finished speaking the phone number, the system repeats it back and announces the available commands.
6. Say: “Dial” C . The system acknowledges the command and makes the call.
For additional command options, see “List of voice commands” later in this section.
Connecting procedure
NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. 1. Push the button on t ...Receiving a call
When you hear the ring tone, push the button on the steering wheel. Once the call has ended, push the button on the steering wheel. NOTE: If you do not wish to take the call when you he ...See also:
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10 seconds
after a single chime has so ...
Receiving a call
When you hear the ring tone, push the
button on the steering wheel.
Once the call has ended, push the
button
on the steering wheel.
NOTE:
If you do not wish to take the call when you
he ...
Use of inboard lower anchors from the outboard seating positions(center seating use)
The lower anchors at the center of the second row rear seat are spaced
400 mm (16 inches) apart. The standardized spacing for LATCH lower
anchors is 280 mm (11 inches) center to center. A child seat ...