Subaru Forester: License plate light - Replacing bulbs - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: License plate light

1. Remove the mounting screws using a

1. Remove the mounting screws using a Phillips screwdriver.

2. Remove the cover and lens.

3. Pull the bulb out of the socket.

4. Install a new bulb.

5. Reinstall the lens and cover.

6. Tighten the mounting screws.

    Rear combination lights
    1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly. 2. Slide the rear combination light assembly rearward and remove it from ...

    Dome light, map light, cargo area light and door step light
    When the door is opened, the map light illuminates and becomes very hot. When replacing the map light bulb, close the door and be careful not to burn yourself. Dome light (type A) Do ...

    See also:

    Corrosion protection
    Your SUBARU has been designed and built to resist corrosion. Special materials and protective finishes have been used on most parts of the vehicle to help maintain fine appearance, strength, a ...

    Setting a warning distance
    This setting determines the distance at which the visual and audible warnings are triggered. Select Long, Normal or Short by pressing MY CAR on the center console control panel and going to Set ...

    A/V-AUX socket, 12-volt socket
    This A/V-AUX socket is used to connect external devices to the RSE system. When connecting an external device, always follow the instructions provided with the device. Devices connected throug ...