Jeep Liberty: Jump-Starting Procedures
If your vehicle has a discharged battery it can be jumpstarted using a set of jumper cables and a battery in another vehicle or by using a portable battery booster pack. Jump-starting can be dangerous if done improperly so please follow the procedures in this section carefully.
NOTE: When using a portable battery booster pack follow the manufacturer’s operating instructions and precautions.
CAUTION!
Do not use a portable battery booster pack or any
other booster source with a system voltage greater
than 12 Volts or damage to the battery, starter motor,
alternator or electrical system may occur.
WARNING!
Do not attempt jump-starting if the battery is frozen.
It could rupture or explode and cause personal injury.
Road Tire Installation
1. Mount the road tire on the axle.
2. Install the remaining lug nuts with the cone shaped
end of the nut toward the wheel. Lightly tighten the lug
nuts.
WARNING!
To avoid the risk of forcing ...
Preparations For Jump-Start
The battery in your vehicle is located in the front of the
engine compartment, behind the left headlight assembly.
NOTE: The positive battery post is covered with a
protective cap. Lift up on the ...
See also:
4WD lock system
4WD lock system (With Electronic Control 4WD) (If installed)
This 4WD system is designed for dividing the
power ratio automatically in normal driving conditions.
During off-road or low-frictio ...
Warranties
The warranties covering your vehicle are explained in a separate New Vehicle
Warranty Information booklet given to you at the time of sale. Please read this
booklet carefully so you can understand ...
Lane Departure Warning (LDW)
For vehicles with LDW, it is intended to help avoid unintentional lane departures.
It may provide a warning if the vehicle is crossing a lane without using a turn
signal. LDW uses a camera sensor ...
