Toyota RAV4: Installing the tire
Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, and the tire may come off the vehicle.
2 Install the tire and loosely tighten each wheel nut by hand by approximately the same amount.
Replacing a steel wheel with a steel wheel
Tighten the nuts until the tapered portion comes into loose contact with the disc wheel seat.
Replacing an aluminum wheel with a steel wheel
Tighten the nuts until the tapered portion comes into loose contact with the disc wheel seat.
Replacing an aluminum wheel with an aluminum wheel
Turn the nut washers until they come into contact with the disc wheel.
3 Lower the vehicle.
Type A
Type B
Type C
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
76 ft•lbf (103 N•m, 10.5 kgf•m)
5 Reinstall the wheel ornament.
16-inch wheel
17-inch and 18-inch wheels
Replacing a flat tire
Chock the tires. 2 Remove the wheel ornament using the wheel nut wrench as shown below. 16-inch wheel To protect the wheel ornament, place a rag between the wrench and the wheel ornament, ...Stowing the flat tire
1 Remove any dirt or foreign matter from the disc wheel seat and the wheel contact surface. Vehicles with aluminum wheels and a steel wheel for the spare: Remove the plastic rings from the wh ...See also:
Checking the vehicle and trailer weight
To check that the weights of the towing vehicle and the trailer comply
with the maximum permissible values, have the vehicle/trailer combination (including
the driver, passengers, and cargo w ...
Front Seat Heater (if equipped)
Front Seat Heater
(if equipped)
With the ignition switch in the “ON” position, push in one or both of the seat
heater switches to warm the corresponding seat(s). The indicator light below th ...
Anchorage location
1) For right seat
2) For center seat
3) For left seat
There is an anchorage located on the rear
edge of the ceiling above each seating
position. ...