Nissan Rogue: Hood - Pre-driving checks and adjustments - Nissan Rogue Owner's ManualNissan Rogue: Hood

- Make sure the hood is completely

- Make sure the hood is completely closed and latched before driving.

Failure to do so could cause the hood to fly open and result in an accident.

- If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

When opening the hood:

When opening the hood:
1. Pull the hood release handle 1 located below the instrument panel; the hood will then spring up slightly.

2. Pull the lever 2 up at the front of the hood with your fingertips.

3. Raise the hood.

4. Remove the support rod from the hood and insert it into the slot 3 .

Hold the coated part A when removing or resetting the support rod. Avoid direct contact with the metal parts, as they may be hot immediately after the engine has been stopped.

When closing the hood:
1. Return the support rod to its original position.

2. Slowly move the hood down to latch the lock.

3. Push the hood down to lock the hood securely into place.

    Setting hazard indicator and horn mode
    This vehicle is set in hazard indicator and horn mode when you first receive the vehicle. In hazard indicator and horn mode, when the LOCK button 1 is pushed, the hazard indicator flashes tw ...

    Lift gate
    - Always be sure the lift gate has been closed securely to prevent it from opening while driving. - Do not drive with the lift gate open. This could allow dangerous exhaust gases to be dra ...

    See also:

    Smooth cornering
    Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be ...

    SRS airbag deployment conditions
    Front airbags ●The SRS front airbags will deploy in the event of an impact that exceeds the set threshold level (the level of force corresponding to an approximately 12 - 18 mph [20 - 30 km/h ...

    To Play the AM/FMRadio
    The ignition switch must be in the ACCESSORY (I) or ON (II) position. Turn the system on by pushing the power/volume knob or the AM or FM button. Adjust the volume by turning the power/volume ...