Range Rover Evoque: Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st, 2nd or reverse gears.
Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3.
Note: HDC is automatically selected by some of the Terrain response special programs.
HDC can be selected at speeds above 80km/h (50mph) but will not engage until vehicle speed drops below 50km/h (30mph). The HDC warning lamp will flash while vehicle speed is above 50km/h (30mph).
The green warning lamp in the message centre will illuminate while HDC is active.
A green graphic will also be displayed in the message centre showing the HDC target speed.
When HDC is unable to operate, the display will be grey. The graphic indicates the range of target speeds available in the currently selected gear. Target speed is adjusted via the cruise control switches.
If HDC is deselected while operating, the green warning lamp will flash and the system will fade out, allowing vehicle speed to gradually increase.
Note: HDC is automatically deselected if the ignition is switched off for more than 6 hours.
READ NEXT:
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steer
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
Brake temperature
In extreme circumstances, the HDC system
may cause brake temperatures to exceed their
pre-set limits. An HDC warning will be
displayed in the message centre. HDC will then
fade out and become temp
SEE MORE:
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure fuel pump delivers a uniform level of pressure to the
shared fuel rail, which serve all 4 fuel
injec
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment jig.
2. The front bumper mounting is replaced in conjunction with:
Front bumper cover
Front bumper
