Jeep Liberty: Hazard Warning Flashers
The Hazard Warning flasher switch is located in the switch bank below the climate controls.
Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.
This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers may wear down your battery.
If Your Engine Overheats
In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action. • On the highways — slow down. • In city traffic — while st ...See also:
Keyless global closing
To initiate global window closing (if enabled),
touch and hold the lock sensor (1) for 3
seconds. This will also single lock the vehicle
and activate the alarm.
Note: The windows will close only w ...
Trailer Hitch Classification
Your vehicle is capable of towing trailers up to 2,000 lbs
(907 kg) without added equipment or alterations to the
standard equipment. Your vehicle may be factory
equipped for safe towing of trai ...
Multi-function lever
Windshield wiper: Rotate the end
of the control away from you to
increase the speed of the wipers;
rotate towards you to decrease the
speed of the wipers.
Windshield washer: Press the end
of t ...