Jeep Liberty: Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.
NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.
High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...Instrument Panel Dimmer
Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights and prevent the interior lights from illuminating when a door is opened. Rotate th ...See also:
Tires
The specified tire pressure is printed in yellow on the emergency/collapsible
spare wheel. ...
Deactivation
Move the gear selector from R to another position.
There is a slight delay in the PAC system,
which means that the view from behind the
vehicle will remain on the screen for approximately
15 se ...
Fuel-filler cap
Fuel-filler cap
To remove the fuel-filler cap:
1. Turn the fuel-filler cap counterclockwise to
remove.
2. Put the fuel-filler cap on the cap holder A
while refueling.
To install the fuel-fi ...