Jeep Liberty: Shift Lever Override
If a malfunction occurs and the shift lever cannot be moved out of the PARK position, you can use the following procedure to temporarily move the shift lever:
1. Firmly apply the parking brake.
2. Using a screwdriver or similar tool, carefully remove the shift lever override access cover, located on the PRNDL bezel.
3. Turn the ignition to the ON/RUN position without starting the engine (engine Off).
4. Press and maintain firm pressure on the brake pedal.
5. Using a screwdriver, reach into the opening and press and hold the shift override lever down.
Shift Lever Override Access
6. Move the shift lever to the NEUTRAL position.
7. The vehicle may then be started in NEUTRAL.
8. Reinstall the shift lever override access cover.
Freeing A Stuck Vehicle
If your vehicle becomes stuck in mud, sand or snow, it
can often be moved by a rocking motion. Turn your
steering wheel right and left to clear the area around the
front wheels. Then shift back ...
Towing A Disabled Vehicle
This section describes procedures for towing a disabled
vehicle using a commercial wrecker service. If the transmission
and drivetrain are operable, disabled vehicles
may also be towed as descri ...
See also:
Power Mirrors
To adjust the mirrors:
1. Move the selector switch to L (left) or R (right) to choose the driver or
passenger mirror.
2. Press the arrows on the control pad to move each mirror in the desired di ...
Air conditioning
The vehicle is equipped with Electronic Climate
Control (ECC). The climate control system
cools, heats or dehumidifies the air in the passenger
compartment.
NOTE
• The air conditioning can b ...
Tongue load
Tongue load
Ensure that the trailer tongue load is from
8 to 11 percent of the total trailer weight
and does not exceed the maximum value
of 200 lbs (90 kg).
1) Jack
2) Bathroom scal ...
