Subaru Forester: Erasing HomeLink® button memory
NOTE
- Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
- It is recommended that upon the sale of the vehicle, the memory of all programmed HomeLink® buttons be erased for security purposes.
1) HomeLink® button 1
2) HomeLink® button 2
3) HomeLink® button 3
1. Press and hold the two outer buttons (button 1 and button 3) until the indicator light begins to flash (after approximately 20 seconds).
2. Release both buttons.
Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light begins to flash slowly (after ap ...In case a problem occurs
If you cannot activate a device using the corresponding HomeLink® button after programming, contact HomeLink® at www.homelink.com or call 1-800-355- 3515 for assistance. ...See also:
Genuine Parts
MITSUBISHI MOTORS has gone to great lengths to bring you a superbly crafted automobile
offering the highest quality and dependability. Use MITSUBISHI MOTORS Genuine Parts,
designed and manufacture ...
Closing
WARNING
Monitor the closing procedure carefully to make sure no one is in danger of being
injured. To prevent possible personal injury, always keep hands and fingers away
from the cargo comp ...
Turning off (stopping) the alarm
If the alarm is sounding, it can be stopped by
pressing the Unlock button on the remote key
or by inserting the remote key in the ignition
slot. Two short flashes from the car's direction
indi ...